X501 HR Cutter — a practical HR cutter for industrial teams
The X501 HR cutter from REAL GAZ is an oxy-fuel cutting unit used where operators need controlled, repeatable cuts in steel.
We explain how to set pressures correctly and which nozzle to fit for plate of a given thickness.
We explain how to set pressures correctly and which nozzle to fit for plate of a given thickness.
Support includes reference to ISO 5172, ISO 2503 and EN 730 for fabrication and maintenance departments.
🏭 Where X501 HR Cutters Are Used
- 🏗️ Plate preparation — cutting blanks and edges before welding or machining;
- 🏭 Production maintenance — replacing worn steel parts on conveyors and frames;
- 🔩 Fastener removal — cutting off seized bolts and rusted studs;
- 🚜 Equipment refurbishment — stripping damaged guards and brackets from heavy machinery.
💡 Why Choose REAL GAZ
- ✅ Repeatable results — consistent flame and cutting jet when correctly set up;
- 🧪 Gases supplied — oxygen and fuel gas cylinders in several sizes;
- 🎯 Nozzle selection — clear guidance by thickness band so nozzles are not wasted;
- 🔒 Safe setup — arrestor, regulator and hose recommendations given before dispatch;
- 📄 Product documentation — supplied with every order.
🔬 Quality Control & Safety
- checking valves and seats before shipment;
- review of thread and fitting types;
- advice on purging lines before ignition;
- cylinder securing and storage reminders.
Cylinders and equipment are supplied in line with ADR / UN transport rules and relevant EN/ISO standards.
📦 Setting Pressures Correctly
Most poor cuts come from wrong pressure settings rather than faulty equipment. We provide a starting guide by thickness and let operators fine-tune from there.
- set the fuel gas first and light the torch;
- adjust the pre-heat flame to neutral, then open cutting oxygen;
- move at a steady speed so the kerf stays narrow;
- stop and re-check if the cut line shows excess slag.
Keep a simple logbook of settings that work for common thicknesses; it saves time and gas for every later job.
📋 How to Order
When you contact REAL GAZ about X501 HR Cutter, please send the work you do most often, the thickness band and the fuel gas on site. With these details our team can reply quickly with a nozzle range and pressure guide for the X501 HR, and can also quote the oxygen, acetylene, propane or other cylinder gases that your work consumes.
Orders are prepared with careful inspection, secure packing and clear handling instructions, so that equipment arrives ready for installation and your operators can start work with confidence. Our engineers are also available to answer questions about safe use, storage, maintenance intervals and replacement parts after delivery.
⚙️ Trusted Gas Solutions
REAL GAZ supports customers across Azerbaijan, Turkey, Georgia, Uzbekistan and the USA. To buy an X501 HR cutter with the matching gases and safety devices, send us your requirements and we will respond with a suitable configuration.
REAL GAZ — consistent cuts, shift after shift.