COOLEX HP NOZZLE — high-performance nozzles for heavy cutting tasks
The Coolex HP Nozzle is chosen for demanding oxy-fuel cutting where flame stability and nozzle life are priorities. REAL GAZ supplies it together with oxygen and fuel gas.
HP in the name points to the heavier-duty model range; we always confirm the exact fit with your torch before supplying.
HP in the name points to the heavier-duty model range; we always confirm the exact fit with your torch before supplying.
Supply is aligned with EN ISO 5172, EN ISO 9013 and EN 730-1, suitable for heavy industry and contracting use.
🏭 Where Coolex HP Nozzles Are Used
- 🏭 Heavy plate cutting — thick plate demands steady heat and sufficient oxygen flow;
- ⚓ Port and marine work — repair crews cut steel on vessels and quay structures;
- 🛢️ Oil and gas fabrication — fabricators cut vessels, skids and structural supports;
- 🏗️ Bulk steel processing — large blanks and offcuts are separated efficiently.
💡 Why Choose REAL GAZ
- ✅ Heavy-duty orientation — a model suited to demanding cutting jobs;
- 🧪 Verified fit — we confirm torch compatibility before shipping;
- 🎯 Whole-set supply — gases, hoses and arrestors in one consignment;
- 🔒 Documented cylinders — each cylinder carries identification and required labelling;
- 📄 Certificate of Analysis (CoA) — supplied with every gas order.
🔬 Quality Control & Safety
- model and bore inspection;
- seat and thread examination;
- gas purity and moisture analysis;
- leak testing and pressure integrity checks.
Gas cylinders supplied with the equipment comply with ADR / UN transport rules and relevant EN/ISO standards.
🛠️ Heavy-Duty Cutting Practice
- For thick sections, start the cut at an edge or pierce at a slight angle to protect the nozzle from slag blow-back.
- Check that the regulator and hoses can deliver the oxygen flow that a large nozzle demands.
- Inspect the nozzle at every cylinder change and keep a replacement ready.
📐 Preparing the Workpiece
Heavy cutting goes better when the plate is prepared. Support the work so the offcut can fall free without pinching the kerf, and leave a clear space under the line of cut for slag. Clean away mill scale and rust along the line when possible, since heavy scale slows initiation. For very thick sections, preheat a small area at the edge until it is bright red before opening the cutting oxygen, and move at a steady pace. Keep spectators away from the sparks, and ensure that there are no combustible materials below. These preparations shorten the cutting time and reduce wear on the nozzle, especially in demanding jobs.
⚙️ Trusted Gas Solutions
REAL GAZ offers the Coolex HP Nozzle with a complete gas and equipment range to heavy industry customers in Azerbaijan, Turkey, Georgia, Uzbekistan and the USA.
REAL GAZ — Power for the heaviest cuts.