METAL WELDING SLEEVE — gas hose for metalworking and fabrication
A metal welding sleeve is the gas hose used wherever steel, aluminium, copper or brass is joined, cut or brazed with a flame.
Metalworking puts a hose under tough conditions: hot spatter, sharp edges and heavy traffic. REAL GAZ chooses compounds that resist heat and abrasion.
Metalworking puts a hose under tough conditions: hot spatter, sharp edges and heavy traffic. REAL GAZ chooses compounds that resist heat and abrasion.
Choose the bore to suit the torch: smaller bores for fine brazing and larger bores for heavy cutting. We can also supply short protective covers where the hose passes close to hot metal or sharp plate edges.
For a metal welding sleeve in daily metal trades use, keep the hose off the floor where possible, route it away from hot workpieces and never allow it to be run over by trolleys or forklifts. Replace any length that has been burnt or crushed.
Typical metal trades orders combine hose with torches, tips and regulators. We can quote these together, label each hose by gas, and deliver to your workshop or site, so crews start work with a matched, leak-tested set rather than loose parts.
REAL GAZ supplies this product according to EN ISO 3821 and ISO 14113 guidance on gas welding equipment, suitable for industrial and workshop use.
🏭 Where Metal Welding Sleeves Are Used
- ⚙️ Structural steel — fitters cut and heat beams and plates with oxy-fuel torches, needing hose that handles hot offcuts and constant repositioning;
- 🔬 Copper and brass brazing — fine work needs a light hose with a small bore so the torch can be controlled precisely around joints;
- 🏥 Sheet metal shops — short lengths keep the torch handy on the bench and reduce the amount of hose lying on the floor;
- 🚀 Foundries — hose is used for preheating moulds and cleaning castings, where radiant heat and metal splashes are common.
💡 Why Choose REAL GAZ
- ✅ Heat resistant — the cover tolerates brief contact with warm metal and radiant heat;
- 🧪 Abrasion resistant — sharp offcuts and rough floors cause less damage to the outer layer;
- 🎯 Wide choice of sizes — bore and length options suit both light and heavy torches;
- 🔒 Clear guidance — we explain how to inspect, store and replace hose;
- 📄 Certificate of Analysis (CoA) — supplied with every order.
🔬 Quality Control & Safety
- cover hardness and flexibility checks;
- pressure testing above working pressure;
- bore diameter verification;
- clean ends sealed for transport.
Cylinders and gas equipment comply with ADR / UN transport rules and relevant EN/ISO standards.
⚙️ Trusted Gas Solutions
REAL GAZ supplies the sleeve to fabricators and metal trade customers in Azerbaijan, Turkey, Georgia, Uzbekistan and the USA, with regulators, torches and gases available on request.
REAL GAZ — Built for working metal.