Sleeve gas welding diameter is 9,0 mm (1metr) — ready-cut 1 metre lengths, 9,0 mm bore
Sleeve gas welding diameter is 9,0 mm (1metr) refers to a gas welding hose with a 9,0 mm bore supplied in a convenient one metre piece.
One metre sections are ideal for jumper leads, short bench connections and quick repairs.
One metre sections are ideal for jumper leads, short bench connections and quick repairs.
Short lengths limit pressure drop and reduce trip hazards. Keep a few spares near the workstation so a damaged jumper never delays a job, and label them by gas service so oxygen and fuel gas pieces are never swapped.
A ready-cut piece described as sleeve gas welding diameter is 9,0 mm (1metr) saves time on the bench, because no measuring or cutting is needed. We supply the pieces with clean ends and can add ferrules or connectors on request.
If you need more than one piece, we can supply several metre lengths on the same order, matched by batch and colour. This is useful when you are equipping a new bench or refurbishing a row of stations at the same time.
REAL GAZ supplies this product according to EN ISO 3821 and EN 559, suitable for industrial and workshop use.
🏭 Where 1 Metre Gas Welding Sleeves Are Used
- ⚙️ Jumper leads — link regulators to manifolds over short distances, where a single metre is enough and keeps the layout tidy;
- 🔬 Bench torches — compact workstations need only a short hose, which keeps the floor clear and the torch easy to reach;
- 🏥 Emergency repair — a damaged section can be replaced within minutes if a ready-cut metre is kept in the tool box;
- 🚀 Calibration and test rigs — short, clean lines suit equipment tests where leak checks and pressure readings are repeated many times.
💡 Why Choose REAL GAZ
- ✅ Ready-cut length — no cutting required before fitting;
- 🧪 9,0 mm bore — dependable flow for cutting and heating;
- 🎯 Low pressure drop — a short run keeps gas pressure steady at the torch;
- 🔒 Convenient spares — easy to hold in stock and replace;
- 📄 Certificate of Analysis (CoA) — supplied with every order.
🔬 Quality Control & Safety
- length check on each piece;
- pressure test of samples;
- bore verification;
- caps fitted before packing.
Cylinders and gas equipment comply with ADR / UN transport rules and relevant EN/ISO standards.
⚙️ Trusted Gas Solutions
REAL GAZ supplies the pieces to workshops in Azerbaijan, Turkey, Georgia, Uzbekistan and the USA, along with clamps, fittings and the gases for your torches.
REAL GAZ — One metre, ready to fit.