Sleeve gas welding diameter is 9,0 mm ( 1metr ) — 1 metre length with a 9,0 mm bore
Sleeve gas welding diameter is 9,0 mm ( 1metr ) describes a gas welding hose with a 9,0 mm internal diameter sold in one metre lengths, so you can order exactly the amount you need.
A 9,0 mm bore carries enough oxygen or fuel gas for medium to heavy cutting tips without excessive pressure drop.
A 9,0 mm bore carries enough oxygen or fuel gas for medium to heavy cutting tips without excessive pressure drop.
Buying by the metre makes it easy to replace a single damaged section, build custom torch leads or stock standard lengths for the workshop. Tell us how many metres you need and whether the hose is for oxygen or fuel gas.
When a listing says sleeve gas welding diameter is 9,0 mm ( 1metr ), the figures matter: the bore decides how much gas can flow, and the length decides how the lead is routed. We confirm both before dispatch and mark the hose clearly for the gas service.
REAL GAZ supplies this product according to EN ISO 3821 and EN 559, suitable for industrial and workshop use.
🏭 Where 9,0 mm Gas Welding Sleeves Are Used
- ⚙️ Custom torch leads — cut the required length for a bench or a mobile cart, then fit connectors and clamps to make a lead that suits your layout exactly;
- 🔬 Replacement sections — swap a worn or burnt length rather than replacing the whole line, which saves money and cuts waste on busy maintenance teams;
- 🏥 Cutting machines — profile cutting machines use measured hose runs from the manifold to the torch carriage, where repeatable lengths simplify installation;
- 🚀 Workshop stock — standard metre lengths are easy to store, count and reorder, which suits small shops with limited storage space.
💡 Why Choose REAL GAZ
- ✅ Order by the metre — buy only the quantity you need and avoid paying for unused hose;
- 🧪 9,0 mm bore — a good balance of flow and flexibility for cutting and heating;
- 🎯 Clear colour coding — oxygen and fuel gas versions are available and easy to tell apart;
- 🔒 Easy to fit — works with standard hose tails, ferrules and clamps;
- 📄 Certificate of Analysis (CoA) — supplied with every order.
🔬 Quality Control & Safety
- length and bore verification on each piece;
- pressure test of production samples;
- cover and lining inspection;
- clean-cut ends sealed at packing.
Cylinders and gas equipment comply with ADR / UN transport rules and relevant EN/ISO standards.
⚙️ Trusted Gas Solutions
REAL GAZ supplies the hose to workshops and distributors in Azerbaijan, Turkey, Georgia, Uzbekistan and the USA, with fittings and clamps for a complete lead, plus regulators and cylinders if you need a full set.
REAL GAZ — Nine millimetres, measured to order.