OXY FUEL CUTTING TORCH 90 DEGREE — angled heads for comfortable flame cutting
An oxy fuel cutting torch 90 degree uses oxygen plus a fuel gas such as acetylene or propane to cut steel, with the head set square to the barrel. REAL GAZ supplies it with the cylinders and safety fittings needed to run it.
The cutting action relies on preheating steel to ignition temperature and then burning it away with a jet of pure oxygen.
The cutting action relies on preheating steel to ignition temperature and then burning it away with a jet of pure oxygen.
Installation advice draws on EN ISO 5172, EN ISO 15615 and ISO 5175-1, covering gas supply and flame protection for cutting stations.
🏭 Where 90 Degree Oxy-Fuel Cutting Torches Are Used
- 🔥 Carbon steel cutting — mild and low alloy steels respond well to the oxy-fuel process;
- 🏭 Plate preparation — edges are cut or bevelled before welding;
- 🧰 Field repairs — portable sets allow cutting where power is unavailable;
- ♻️ Recycling — scrap steel is reduced to a size suitable for processing.
💡 Why Choose REAL GAZ
- ✅ No electricity needed — the process works in remote locations;
- 🧪 Thick material — oxy-fuel handles sections that thin-section tools cannot;
- 🎯 Ergonomic angle — the 90 degree head helps the operator see the cut;
- 🔒 Full supply — gases, regulators and arresters from one source;
- 📄 Supplier documentation — supplied with every order, together with gas Certificates of Analysis (CoA) where cylinders are included.
🔧 Handling & Technical Notes
Oxy-fuel cutting works on carbon and low alloy steels but not on stainless steel or aluminium, which form refractory oxides. Provide good ventilation, as cutting fume contains metal oxides, and remove paint, galvanising or coatings where possible before heating. Keep fuel cylinders upright and chained, and close all valves after finishing work.
Preheat temperature for steel is around 900 degrees Celsius, the point at which iron burns readily in a stream of pure oxygen. The resulting iron oxide melts at a lower temperature than steel, so the jet blows it away as slag. This explains why clean plate cuts quickly, while rust, scale and paint can slow the start and should be cleaned from the cutting line first.
- suitable only for carbon and low alloy steel;
- ventilation and fume control;
- cylinders upright and secured.
🔬 Quality Control & Safety
- incoming inspection of valves, seats and threads;
- gas tightness checks before dispatch;
- oxygen-clean handling of all fittings;
- pressure integrity checks on cylinders supplied with the set.
Cylinders comply with ADR / UN transport rules and relevant EN/ISO standards.
⚙️ Trusted Gas Solutions
REAL GAZ supplies the oxy fuel cutting torch 90 degree and the oxygen, acetylene and propane to run it, serving customers in Azerbaijan, Turkey, Georgia, Uzbekistan and the USA.
REAL GAZ — torches and gases for dependable steel cutting.