KRASS Cutting Nozzle №3 — reliable mid-size performance and easy upkeep
The KRASS Cutting Nozzle №3 is a practical choice for steady work on medium plate. Its value comes from easy operation and straightforward upkeep, so that welders and cutters can rely on it shift after shift.
REAL GAZ supplies the nozzle with simple setup advice, because most poor cuts come from setup errors rather than from the nozzle itself.
REAL GAZ supplies the nozzle with simple setup advice, because most poor cuts come from setup errors rather than from the nozzle itself.
Guidance is based on EN ISO 5172, ISO 9012 and EN ISO 9013, for operators and supervisors responsible for cutting quality.
Good results also depend on correct pressures. Too little cutting oxygen leaves the cut incomplete, while too much widens the kerf and wastes gas. Set pressures from the torch maker table, test on scrap of the same thickness and adjust the travel speed until the slag stream leaves the underside at a slight backward angle.
🏭 Where KRASS №3 Nozzles Are Used
- 🧱 Civil engineering — cutting reinforcement plates, steel supports and formwork components on construction sites;
- 🚛 Heavy vehicle repair — removing and shaping worn plate on buckets, bodies and trailers;
- ⚙️ Equipment manufacturing — preparing blanks for welded frames, covers and guards;
- 🏫 Training workshops — giving students a forgiving mid-size nozzle for learning gas cutting technique.
💡 Why Choose REAL GAZ
- ✅ Forgiving operation — the mid-range size tolerates small variations in speed and stand-off better than very small tips;
- 🧪 Simple maintenance — accessible orifices can be cleaned quickly between cuts;
- 🎯 Setup support — we supply typical pressure ranges and flame settings for you to verify against your torch manual;
- 🔒 Consistent supply — repeat orders of the same nozzle keep every station in your shop identical;
- 📄 Certificate of Analysis (CoA) — supplied with every order.
🔬 Quality Control & Safety
- dimensional check of the seat and thread;
- orifice and bore inspection;
- flame test before dispatch;
- dry, protected packing.
Cylinders comply with ADR / UN transport rules and relevant EN/ISO standards.
🧰 Routine Care Steps
- Clean the preheat holes and cutting-oxygen bore before each shift using the right needles;
- Check the seat for scratches and replace the nozzle if leaks persist;
- Purge hoses before lighting, then ignite with a spark lighter rather than matches.
⚙️ Trusted Gas Solutions
REAL GAZ supplies the KRASS Cutting Nozzle №3 and companion gases to workshops, contractors and schools in Azerbaijan, Turkey, Georgia, Uzbekistan and the USA. Reach out if you need help with torch compatibility, spare-part planning or a regular cylinder delivery schedule for your cutting area.
REAL GAZ — steady cuts, simple upkeep.